GB3JB came back on air at approx., 3:45 pm this afternoon, running on 8 watts ERP.
The batteries are still quite low - the d.c. rail is only 22.8 volts, so we still have quite a way to go to get the system back up to a fully charged state. It shows how little UV and wind there has been at the site over the last 5 days.
The forcast for tonight and tomorrow is for high wind, so with a bit of luck, we should get a good charge over the next 24 hours.
However, it would be appreciated if use is kept to a minimum, for the next day or so.
Dave, G3ZXX, is planning to go up to the site tomorrow (Tuesday) afternoon, to return the repeater to it's nominal 25 watts ERP, if the batteries are back to their nominal status, by then.
GO TO OUR NEW WEB SITE
Please click HERE to go to our NEW web site.
These pages are no longer being updated.
Please also note that the "Contact Us" e-mail address, shown here is no longer available.
Pages
SITE LAST UPDATED ON: Saturday, 10/01/2015 @ 4:35 pm local time.
RV63 - Out 145.7875 MHz - In 145.1875 MHz - 103.5 Hz ctcss (G).
The system is located in South Wiltshire, in IO81vc, and provides coverage across South Wiltshire, South Somerset and North Dorset, with specific areas such as the City of Salisbury, Salisbury Plain, the Blackmore Vale and Cranborne Chase being well within its range. Coverage also extends, for fixed stations, across most of central and parts of North Wiltshire, Southern Dorset and West Hampshire, plus parts of North and West Somerset. See coverage map.
GB3JB is an analogue voice repeater, with no internet linking, simple intuitive logic and no bells or whistles. The beacon sends callsign and locator. The invitation to transmit is a single dit.
The simple rules for using GB3JB ....
(2) All users of GB3JB are expected to operate their station within the terms of their specific licence conditions and restrictions.
(3) When in QSO, please wait for the invitation to transmit (a single dit), and always leave a pause between overs' - always give others a chance to call-in.
(4) Please use good operating practices and procedures. Mobiles have priority. Remember, if a station calls in, during the gap between overs', always acknowledge them and please DON'T leave them sitting on the side, while everyone else has an over.
(6) If, under lift conditions, you wish to use another repeater on RV63, please turn off the 103.5 Hz ctcss tone, otherwise you will still access GB3JB.
(7) Remember that you are Radio Amateurs, using an Amateur Radio facility, so please use the appropriate operating practices and procedures.
Since you have taken the trouble to get an Amateur Licence, surely it's not to much to expect of you, that you use Amateur Radio abbreviation and accepted terminology, such as the Q-codes. We do not have a '20', we have a 'location' or 'QTH'. We do not have a 'personal', we have a 'name', etc., etc., If you still use CB, that's fine, no problem, BUT please leave the CB lingo for CB, and not when you use GB3JB or any other Amateur Radio facility or the Amateur bands.
(8) Ignore any idots - If you don't hear a callsign, do NOT respond - EVER !
